Transport, offloading, setting up
4
________________________________________________________________________________________
_______________________________________
4/5
(3). The strops should be drawn as high as possible above the machine so as
to ensure no contact with any part of the arm and aggregate.
All additional components including the control console are tied onto the top of the
machine so will be removed when the machine is removed.
Care must be taken to ensure that the strop is not hooked around any of the
cables, hoses or switchgear. It is also important that the strops do not pull
against any part of the working head.
A block of wood or similar should be wedged under the strop as it loops up
over the front cover so as to prevent damage to the covers and switchgear.
Care must also be taken when removing the machine finally from the container
that it does not drop down onto the control cabinet which is affixed to the end
of the machine and is not designed to support the machine.
A suitable forklift may also be used.
The fork-lift truck must have a load-bearing capacity sufficient to take up the weight
of the machine (see Specifications on the order sheet) and ensure the forks do not
crush any cables or hoses which pass underneath the frame of the machine.
Fork extensions should be used if necessary to ensure the forks safely extend
beyond the furthest lifting point.
Please remember that this is a piece of precision machinery - so avoid knocking or
abruptly lowering the machine during all handling operations. Do not carry the
machine by its functional parts.
CAUTION !
4
Summary of Contents for Revolution 180
Page 1: ...Operating Manual...