Run
9
________________________________________________________________________________________
_______________________________________
9
-
2
There are two ways to prepare
The C Axis position, in preparation
For loading a new roll of band.
Either by using the control switch (988)
(see 07 Control Panel), rotate
the C Axis fully until it reaches
it’s clockwise limit (when viewed
from above).
Alternatively it is possible to use the
Tape Change function which can be
found on the FUNCTIONS PAGE
which is accessed via the
functions icon (89)
On the functions page, activate the
Tape Change function (990).
this will bring the head forward in Y
to the front of the table and will
wind the C Axis clockwise to its
load position.
988
989
990
Summary of Contents for Revolution 180
Page 1: ...Operating Manual...