Run
9
________________________________________________________________________________________
_______________________________________
9
-
6
It is also possible to check that this infeed roller (910) is set correctly by watching as the
band feeds across the nozzle. It should just brush across the top of the guide pin (911)
which is positioned just after the nozzle.
If the top tape guide (908) is too loose, or if the infeed roller (910) is pushing down too
hard, the tape will not track perfectly along the top of this guide pin (975)
If the next workpiece has a butt join (ie. A 360 degree banding of the top) then the end of
the band needs to be trimmed manually so as to ensure a perfect join.
This is achieved by pushing the band right through past the glue nozzle and out the other
side so as to allow the off-cut to be easily removed.
Then after checking that the end trim unit is free of obstruction and ensuring that no other
person has their hands anywhere near the unit, a manual cut can be performed. This is
achieved using the Saw Mode on the functions page.
975
910
Summary of Contents for Revolution 180
Page 1: ...Operating Manual...
