Run
9
________________________________________________________________________________________
_______________________________________
9
-
8
If a non-360 degree panel is to be performed, it is usually unnecessary to pre-trim the tape
as the condition of the end of the tape is not important provide it is square.
For either cycle (360 or non-360) the tape should always start in line with the cut line (932)
of the end trim.
Note: activating the tape present switch (911) will bring up the Clear Tape alarm on the
screen. This can be cleared by pressing the screen button Reset Alarms when the tape
has been cleared.
932
911
909
908
Position tape should be at
commencement of cycle.
Picture shown with end trim unit
in “down” position.
Summary of Contents for Revolution 180
Page 1: ...Operating Manual...
