Run
9
________________________________________________________________________________________
_______________________________________
9
-
19
From this it is possible to check that the glue is flowing correctly, is the correct width and
that the tape is sitting correctly on the exit guide pin (975) (to ensure laying on the panel at
the correct height). The edge material should just brush this pin.
When sufficient tape has been run, the feed can be stopped by pressing the tape feed
(994) on the Functions page again. This will exit the Function Page and return to the
Controls page while also stopping the feed.
At this point, the edge material which has been fed over the nozzle remains pressed
against the hot nozzle so should be cut off and removed promptly.
To cut off the edge material, follow the procedure in
9.1.2 Manual Saw cut.
Having cut the material, remove the edgetape/glue line test piece from the nozzle by
pulling firmly.
Note, it is important to remove this material promptly or the nozzle may soften the
tape sufficiently that it will pull apart when being removed and leave a section of
edge material in the guide.
The image below shows a good quality glue line.
975
911
975
Summary of Contents for Revolution 180
Page 1: ...Operating Manual...