Run
9
________________________________________________________________________________________
_______________________________________
9
-
24
9.1.8.1
360 Degree Operation
When in 360 degree mode, the machine is set to start against the edge of the panel such
that the tape start will begin in the desired place. When the aggregate has aligned itself
against the panel, feed motor will begin progressing it around the panel. Tape feeding will
commence immediately.
When the aggregate has almost completed the 360 degree circuit of the panel, the end of
tape sensing arm (938) will automatically swing out and the feed speed will slow.
When the first sensing switch (934) is activated by the leading edge of the tape, the feed
slows to a crawl. When the second switch (935) is activated, the feed stops and the end
trim guillotine cuts the edge material.
Adjustment of the join is achieved by moving the switch block along the sensor arm and is
controlled via a digital counter (940).
This is achieved by releasing the locking knob (936) and winding the counter in the
direction desired. A larger number makes the gap wider. A smaller number makes the
gap smaller.
934
935
940
936
Summary of Contents for Revolution 180
Page 1: ...Operating Manual...
