Run
9
________________________________________________________________________________________
_______________________________________
9
-
30
The following drawing shows a template for a universal Pod Plate (967) which can be
manufactured as a blank with the 8 diameter holes and notches for end trimming.
There is also on the drawing a dotted line (968) representing the EndPOD on which the
Universal Pod Plate sits. It is important that there is 45mm clearance from this baseplate
to allow the trimmer tracer shoes clearance.
From this universal plate however, it is possible to for example, cut an angle (969)on the
appropriate side to make a lead-in to more closely match the lead of the workpiece.
Note however, it is not critical that they exactly match, simply that the banding should lay
flat on the workpiece edge and that the transition of the band head onto and off the panel
should be smooth.
966
965
Tap M6
964
967
968
969
Summary of Contents for Revolution 180
Page 1: ...Operating Manual...