Run
9
________________________________________________________________________________________
_______________________________________
9
-
32
In
non-360 DEGREE MODE
, the cycle has some differences to when running in 360
DEGREE MODE.
Firstly, on pressing the Start Cycle button, the tape will commence feeding at the same
time as the z axis is lowering. This pre-feeds the tape into the tape guide so that if feeds
earlier onto the panel (requiring a shorter starting block).
This cycle is distinguishable from the 360-Degree Mode because when the z axis reaches
its lower limit, the head will pause to allow the tape to finish pre-feeding , before it
commences movement towards the workpiece.
When in non-360 degree mode, it is possible to select from two operating states by
choosing LENGTH CUT ON/OFF (950).
When the indicator (950) is RED, the mode LENGTH CUT is ON. When it is GREY, the
mode LENGTH CUT is OFF.
To turn the LENGTH CUT on or off, it is necessary to go into the advanced controls page
which is accessed by touching the 360 Panel wording (951) which is situated below the
icon.
This opens the Advanced Controls: 360 Panel page and on this page it is possible to
change the status of the LENGTH CUT setting using the radio button (950).
926
993
933
950
951
Summary of Contents for Revolution 180
Page 1: ...Operating Manual...
