Run
9
________________________________________________________________________________________
_______________________________________
9
-
34
This distance of travel for the trimmer and scraper can be controlled by the operator (refer
section
9.3
) If the finish point of the tape cut is to be changed, this is effected by moving
the position of the cam.
When LENGTH CUT “ON” is selected, the cycle starts in the same way as above with the
difference being that the sensing arm (938) does not swing out. There is a length cut
distance on the screen (953 and 954) which set the distance that the head will travel
(cm)before automatically stopping and performing the end cut.
The LENGTH CUT distance is controlled by parameter Length Cut L (954) when using the
L field start position and is controlled by parameter Length Cut R (953) when using the R
field start position. This value can be manually entered, pulled from a previous setting
programme or alternatively taught to the machine by the operator.
This teach function is achieved by first manually entering the number 99999. This is a
number larger than any panel length and hence will not make a premature cut. The cycle
is then run and at the point where the head reaches the position where it is appropriate to
cut the edgetape, the manual END CYCLE button (959) is pushed. This automatically
sets the count measure which will now be displayed on the screen.
The autocut parameter will set for each workzone independently allowing different cut
lengths in each field.
Refer section 9.1.9 Setting Vacuum Cups and workzones.
This AUTOCUT DISTANCE can now be manually adjusted on the screen by changing the
parameter (58a or 58b) up or down as appropriate. The counts are approximately in cm.
926
993
933
950
951
959
960
Summary of Contents for Revolution 180
Page 1: ...Operating Manual...
