Run
9
________________________________________________________________________________________
_______________________________________
9
-
40
These scales are calibrated to match the position of the central axis of the C shaft which
corresponds to the second pressure roller (951).
Thus for example, if an X position of 150 is set, Y position 100 and C 0 degrees, the head
will move so that the C roller (951) will move to this position and the head will rotate to the
0 degrees position which is facing the right hand side of the panel.
NOTE: If a butt join (360 degree) panel is being performed, the butt join will be offset by
23 (23cm) from the C roller. This obviously depends on the angle the head is facing, so if
the start is at 0 degrees in C, then the butt join will be offset in the Y + direction. Similarly
if the C angle is 90 degrees, the butt join will be offset in the C negative direction.
This is because the edgeband starts the cycle positioned at the end trim point (952) in the
tape guide and as the cycle starts, the head moves and lays the tape down 23 cm after
the start position of the C roller.
Method 2:
The second method is to manually move the aggregate using the joy stick (919) and C
Axis control switch (918) to the desired position and save the position using the Save
position key (956).
A combination of these two methods can be used together in conjunction with the toggle
between fields key (943) to easily set start and park positions for the machine.
At the completion of each cycle, the target position automatically toggles to the other
position. For example; if the target position is presently in the second position (945), then
on completion of the cycle, the target position will automatically toggle to the first position
(944) and the aggregate will move there on completion of the cycle.
Conversely, if the initial target position is (944) then on completion of the cycle it will toggle
to position (945) and move there and sit.
951
952
Summary of Contents for Revolution 180
Page 1: ...Operating Manual...