Run
9
________________________________________________________________________________________
_______________________________________
9
-
43
9.2.4 Start Cycle.
When the panel is sucked down onto the vacuum pods, the aggregate is in the start
position and all the settings are as desired (including glue temperature reached), a cycle
can begin.
To start a cycle, upon pressing the Start cycle pushbutton (960), provided all of the “Start
Prevent” conditions are met (see section 9.2.5.1) the cycle will start.
NOTE: If the cycle does not start, push an hold the start pushbutton (960) and a message
(947) will appear on the screen status bar advising the reason.
The cycle will commences with the aggregate lowering onto it’s z-down stop. Depending
on the angle which it is facing at this point, it will move at a slow speed until the sensor
S28 Board sensor detects the edge of the panel. The Screen message Approach Work
will appear on the screen until the workpiece is detected.
Note: the direction of travel to approach the board switches at 45 degree increments.
Thus for example when the C axis reads up to 45 degrees, the approach to the board will
be in the negative X direction. When above 45 degrees the approach to the board will be
in the negative Y direction and similarly all the way around the panel.
This needs to be considered when setting the start angle for the aggregate.
An explanation of the different automatic functions during a cycle are detailed in the
section 9.3.
Ensure all personnel are clear of the machine and that there is no possibility for the
aggregate to drop onto any objects on the worktable causing damage.
CAUTION !
926
993
933
950
951
959
960
947
Summary of Contents for Revolution 180
Page 1: ...Operating Manual...
