13
7.1
BULB REPLACEMENT
Tools needed - small Phillips screwdriver.
1. Unscrew (counterclockwise) and remove two Phillips screws.
2. Remove the lens cover.
3. Remove the burned-out bulb.
4. Replace with a new bulb (12 Volt 0.2 amp Krypton bulb).
5. Snap the lens cover back into place.
6. Replace (clockwise) the screws and carefully tighten. Do not over tighten!
7.2
BATTERY REPLACEMENT
It is recommended that the unit be returned to Vector Customer Service
for battery replacement: Contact (954) 584-4446 or toll-free
(866) 584-5504.
WARNING:
• Do not dispose of the battery in fire as this may result in an explosion
• Before disposing of the battery, protect exposed terminals with heavy-duty electrical
tape to prevent shorting (shorting can result in injury or fire)
• Do not expose battery to fire or intense heat as it may explode
7.3
BATTERY DISPOSAL:
This unit contains a maintenance-free, non-spillable, sealed lead-acid
battery. This battery is fully recyclable and should be accepted at any
location that accepts common automotive starter batteries. Examples of
places that accept these batteries are: County or municipal recycling
drop-off centers, scrap metal dealers and retailers who sell automotive
replacement lead acid starter batteries. For more information on
recycling this battery, call toll-free (877) 288-7722.
8.
SPECIFICATIONS
Model ................................................................................. VEC021APC
Boost Ampere ..................................... 450 Instantaneous Cranking Amps
Peak Ampere ....................................................................... 1200 Amps
Battery Type ....................... Sealed, high energy density, AGM, lead-acid,
..............
rechargeable, maintenance-free, 12 volt DC, 19 Amp-hour
Bulb .................................................... PR type 12 Volt 0.2 Amp Krypton
Booster Cables ......................................... Heavy duty welding cable with
.................................................................
450 Amp copper clamps
Accessory Socket ..................................... Self-Resetting Breaker 20 Amps
DC Charging Adapter ............................................................ 12 Volt DC
AC Charging Adapter ...... 110/120 Volt AC (700mA, 12 Volt DC Output)
Reverse Polarity Detection .................................................... 2 Volts (min)
HEIGHT ................................................................... 11.75 in. (29.8 cm)
DEPTH ............................................................................8.25 in (21 cm)
WIDTH ................................................................... 11.625 in (29.5 cm)
WEIGHT ..................................................................... 19.1 lb. (8.66 Kg)
Vec021APC manual 10/02
12/3/02, 10:57 AM
13
