background image

7

2.

USING THE VECTOR

®

 AS A JUMP-START SYSTEM

WARNING:

1. Before using this system to jump-start any vehicle or boat, read and understand

all instructions, safety tips, warnings, cautions and first aid information

provided in this manual and on the product labeling. Additional important

information may also be provided by the vehicle’s battery system manufacturer.

2. Be aware of first aid procedures before attempting jump-start procedure.

3. Always wear protective eyewear when working with a lead acid-type battery.

4. Do not smoke or use inflammable items (matches, cigarette lighters, etc.) while

working on a vehicle’s battery system.

5. When using this jump-starter in proximity to the vehicle’s battery and engine,

stand the unit on a flat, stable surface, and be sure to keep all cords and cables

well away from any moving parts.

6. Check unit periodically for wear and tear. Replace worn or defective parts

immediately contact Vector Customer Service Department toll-free:

(866) 584-5504 or through our Internet address: www.vectormfg.com.

7. Do not attempt to jump-start a frozen battery.

8. NEVER submerge this unit in water.

9. Do not wear vinyl clothing when jump-starting a vehicle, friction can cause

dangerous static electricity sparks. Remove all jewelry or metal objects-they can

cause short circuits or react with battery acid to cause severe burns. Remove or

secure any loose clothing, and restrain long hair, before attempting jump-start

procedure.

10.  Lead-acid batteries generate hydrogen gas during normal operation. More gas is

generated when the battery is charging. Hydrogen gas is explosive, poisonous

to breathe and highly flammable.

Recommendations for optimum performance of the VECTOR

®

 Jump-starter:

CAUTION:

1. To avoid possible damage that may shorten the unit’s working life, protect this

unit from direct sunlight, direct heat and moisture.

2. This system is to be used ONLY on vehicles, boats, garden tractors and gasoline

powered generators with 12 Volt DC battery systems.

3. This system is NOT designed to be installed as a replacement for a vehicle battery.

4. Vehicles that have on-board computerized systems may be damaged if vehicle

battery is jump-started. Before jump-starting this type of vehicle, read the vehicle

owner’s manual to confirm that external-starting assistance is advised.

5. Excessive engine cranking can damage the vehicle’s starter motor. If the engine

fails to start after the recommended number of attempts, discontinue jump-start

procedure and look for other problems that may need to be corrected.

6. This VECTOR

®

 jump-starter is equipped with an internal, automatic

safety switch. This switch only activates when connections to the battery are

correctly made;positive (+) to positive (+) and negative (-) to negative (-).  An

incorrect connection will sound an audible alarm indicating an incorrect

connection.  Should this alarm sound, remove the clamps and reconnect insuring

proper polarity.  Once the connections are properly made, the internal switch

turns on and you are ready to jump-start the vehicle.  This automatic internal

safety switch is fully automatic and requires no action by the user.

Vec021APC manual 10/02

12/3/02, 10:57 AM

7

Summary of Contents for Start-It VEC021APC

















Reviews: