Page 15
10.0 - Jib Sheet System
Install the 20mm single block on the jib traveler car, mounted to the front cross bar,
with the 1/8” bow shackle.
10.1 - Jib Rotation Limiter
Tie the 3mm jib traveler line to the
center of the jib car. Feed this
line then through the single pivot
block mounted approximately 1
foot forward on the spin pole.
After exiting this block then return
the line through either of the 2
cam cleats mounted on the
forward cross bar between the jib
track pylons. By pulling on this
line and cleating, the jib travel is
restricted. Releasing this line will
allow the jib car to travel further
outboard.
10.2 - Jib Sheet
Run the 3mm spec tine through
the block now mounted on the jib traveler car. Tie a 1/8” bow shackle to the upper
side, which will be used to connect to the jib clew plate. ON the lower side of this
line, tie the 30mm single block.
Feed the 6mm jib sheet line first through
the pivoting cleat mounted on either of the
jib track pylon posts. Run this then
forward through one of the blocks attached
to the pelican striker assembly. Then turn
aft and through the 30 block attached to
the jib clew line, and then back again to
the other forward block on the pelican striker.
Return the final time back through the
opposite pivot cleat mounted on the other
side of the jib track. The loose ends of the jib
sheet can then be tied or run to make
convenient for your sailing style.
Fig 10.A
Fig 10.B
Fig 10.C
