35
Vectron POS Mobile
Pro
MobilePro
US
Battery voltage display
The POS MobilePro has different possibilities to signal that the bat-
tery is low and should be exchanged. Normally a window is faded
in with the request „Charge battery“. Additional optical and acoustic
signals can be confi gured.
In running mode you can fade in a progress bar to display the vol-
tage of the battery.
Battery protection circuit
The Vectron POS MobilePro has a battery protection circuit, which
checks the voltage of a newly inserted battery. In case the battery
does not have the required minimum voltage, the red LED fl ashes
twice when being switched on (see below).
If, however, the battery exchange takes place in less than three se-
conds, the battery protection circuit cannot always recognize the
battery exchange correctly. Here, too, the red LED would fl ash twice
when being switched on. You should therefore take at least three
seconds for the exchange of the battery. Should the POS MobilePro
erroneously reject a charged battery, you can either take the battery
out of the terminal for three seconds or put the terminal with the
battery into the charging station for a short time. The POS MobilePro
will then recognize the charged battery correctly.
Summary of Contents for POS MobilePro
