59
Vectron POS Mobile
Pro
MobilePro
US
Putting into operation
7
In this chapter we will explain how to start the Vectron POS Mobi-
lePro.
Note
Your local Vectron dealer has already made the pre-
parational work so that the Vectron POS MobilePro is
ready for operation. Please ask him to assist you with
the fi rst starting.
Please check in particular the following aspects with your local
dealer:
1. Make sure your POS system is equipped according to your order.
2. The Vectron POS MobilePro is basically designed to work in an
ECR network. In this network you require at least one access
point, which establishes a wireless network connection between
stationary Vectron POS systems or Vectron POS PC and Vectron
POS MobilePro. Please heed the following:
a.
Configuration of the access point
Please ask your dealer to configure the access point so that a
wireless network connection between the participating Vec-
tron POS systems can be established.
b.
Installation of access point
Select a central set up site. The access point should be in-
stalled in min. 2 m height, measured from bottom.
c.
Compatibility
Prerequisite for operating the Vectron POS MobilePro in an
ECR network is that all participating Vectron POS systems use
the same Vectron POS software version. For technical reasons,
version Vectron POS 4.0.1.0 or higher must be used.
Summary of Contents for POS MobilePro
