VEC-121K Owner's Manual
Crystal Radio Set Kit
18
Only a few more steps remain, and the set will be finished.
Refer to the drawing below for the last wiring steps.
DET2
EAR1
!
Cut a 4½” length of 18 AWG enamel wire from the wire spool in the kit.
!
Remove 1” of insulation from each end.
!
Form each end of the wire into an
end
connection.
!
Loosen the screws mounting the Fahnstock clips
DET2
and
EAR1
.
!
Take one of the wire
end
connections and place between the
DET2
clip and
breadboard.
!
Tighten the mounting screw for the
DET2
clip until snug.
!
The remaining
end
connection is placed between the
EAR1
clip and
breadboard.
!
Tighten the mounting screw for clip
EAR1
until snug.
Summary of Contents for VEC-121K
Page 31: ......