9
4
Assembling AKITA JET Inhalation System
On each occasion before starting the equipment, as well as after periods of non-use, please comply
with the cleaning instructions in section 5. Ensure that the nebuliser set was cleaned, disinfected and, if
necessary, sterilised after the last treatment.
CAUTION:
•
Make sure that the AKITA JET control unit is placed upright on a flat surface and that the air
ventilation slots on the backside are not blocked.
4.1
Connection of Power Supply and Power Cord
Fig. 1: Connect the power supply cable with the jack at the back
of the control unit.
Fig. 2: Connect the power supply with the power cord.
Plug the power cord into a suitable socket outlet.
4.2
Inserting Smart Card
Insert the Smart Card, which complies with the intended therapy into the card slot of the AKITA JET.
Make sure that the chip on the Smart Card is pointed down and that the arrow points in the direction of
the card slot. The card is correctly inserted when it is flush with the front of the control unit. Do not
switch on the device now.