4. nCal – The display shows the number of the performed actions in
service mode.
6. Operation with the rechargeable battery
e with an adapter, bought
he case. During the recharging the scale can operate or
y is fully recharged for approximately 8 hours.
he current voltage of the battery can be checked from menu 1.Bat of the scale.
When “
restore
7. Err
The charging of the rechargeable battery is mad
together with the scale. The adapter should be plugged in the 12V DC jack that
is on the right side of t
can be switched off. The batter
T
battery” symbol is shown on the display, please recharge the battery as
soon as possible. In reaching impermissibly low voltages, the display turns off
and the scale operation is blocked till the normal values of the voltage are
d (plug in the adaptor).
ors
the error does not disappear contact
Err2 – when it is shown after passing the indication test it means that the
red in the memory is detected to be incorrect.
-HI-“ – overloading indication – a load over the maximum capacity is
ed on the platform
Err1 – it is shown after passing the indication test when the load cell is
deformed of overloading or due to some reason the platform is heavier.
The extra load should be removed. If
the nearest service centre.
load cell is deformed backwards or the platform is lightened. Place the
pan on the scale or if it is on its place contact the nearest service centre.
Err3 – after the initial zero- setting the weight of the platform is below
the given limits. Probably the pan has been removed during the operation
or something is raising it.
Err4 – the scale is loaded with so extremely heavy load that it cannot be
read by the electronic block. If the scale is unloaded contact the nearest
service centre.
Err5 – It is shown on the display with turning on the scale when due to
some reason the data sto
“
plac
