5
41
3.3Vaux
3.3Vaux 3.3Vaux
I
Supply input
Connectto3.3V
42
LED_WWAN#
NC
N/A
Internally not connected
43
GND
GND
GND
N/A
Ground
Connect to ground
44
LED_WLAN#
NC
N/A
Internally not connected
45
Reserved
NC
I/O
46
LED_WPAN#
NC
N/A
Internally not connected
47
Reserved
NC
I/O
48
1.5V
NC
N/A
Internally not connected
49
Reserved
NC
I/O
50
GND
GND
GND
N/A
Ground
Connect to ground
51 W_DISABLE2#
NC
I/O
52
3.3Vaux
3.3Vaux 3.3Vaux
I
Supply input
Connect to 3.3V
2.2
Module supply input
RG-1008M card must be supplied through the 3.3Vaux pins by a DC power supply. The voltage must be
stable, because during this operation the current drawn from 3.3Vaux can vary significantly, based on the
power consumption profile of the SX1301 chip (see SX1301 DS).
2.3
Antenna RF interfaces
The modules have one RF interfaces over a standard MHF connector with a characteristic impedance of
50Ω. The RF port (CN2) supports both Tx and Rx, providing the antenna interface.
2.4
USB interface
It includes a high-speed USB 2.0 compliant interface with maximum 480 Mb/s data rate, representing the
interface for any communication with an external host application processor. The module itself acts as a USB
device and can be connected to any USB host equipped with compatible drivers.
2.5
Reset
The card includes the RESET active-low input signal to reset the CPU.
3
Operating Conditions
3.1
Operating temperature range
Parameter
Min
.
Typ.
Max.
Unit
Remark
operating temperature
–40 +25
+80
°C
Normal operating temperature
