16
EMR
3
- Truck Installations
EMR4 Truck Installation
C&C Mode Switch
C&C Mode Switch
The C&C corner switch assembly (P/N 845900-018) that fits into one corner of the Display Head’s housing (see
Figure9). To enter C&C mode, remove the corner bolt from the Display Head’s cover. To exit C&C mode, replace
the bolt. When using the corner switch, remove the C&C jumper.
Installing Optional Keypad Kit - Right
O
r Left Side
Figure9 shows the installation and wiring of the optional keypad. To attach the keypad housing mounting screws,
you will need to pull/slide up the display assembly away from the Display Head. Insert the keypad wires through
the center hole in the gasket, slide the gasket down against the keypad and align its three holes with the mounting
holes in the keypad. Hold the keypad against the Display Head and screw in the 3 mounting screws, replace the
display assembly and then connect the keypad wiring to the terminal block as shown in Figure9. The screws are
self-tapping. The user may want to pre-tap the holes using the screw to ease installation.
Installing The Remote Display (Optional)
The Remote Display consists of the items listed in Table 2:
Figure 10 shows the Remote Display assembly and Figure 11 shows how to wire the display to the Interconnect
Box. You can mount the display on a wall or dashboard of a truck, a wall in a building, or outside in a hazardous
location. Use appropriate fasteners in any of the pre-drilled holes in the base of the optional bracket when
attaching the bracket to the mounting surface. Adjust the angle of the display by loosening the side bolts and
rotating the unit to the desired position.
Following wiring routing precautions and procedures discussed earlier (page 14) for the meter mounted Display
Head, connect the Remote Display to the Interconnect Box. Wiring connections at the Remote Display are shown
in Figure 11. Install optional cord grip fitting in rear of Remote Display for cable egress. Wiring connections at the
IB are to the identical terminals of the unused Display Head terminal block.
Table 2. Remote Display (84559X-00X) Components
Description
V-R P/N
Remote Display install kit
330020-430
Opt. Mounting Bracket kit
845900-024
Opt. 4 conductor cable - 6 ft (1.83 m)
846000-107
Opt. 4 conductor cable - 35 ft (10.67 m)
846000-106
Opt. 4 conductor cable - 50 ft (15.24 m)
846000-100
Opt. 4 conductor cable - 100 ft (30.48 m)
846000-101
Opt. 4 conductor cable - 200 ft (60.96 m)
846000-102
Opt. 4 conductor cable - 300 ft (91.44 m)
846000-103
Opt. 4 conductor cable - 400 ft (121.92 m)
846000-104
Opt. 4 conductor cable - 500 ft (152.4 m)
846000-105
