1
Introduction
ProtoNode Gateway
The ProtoNode is an external, high performance building automation multi-protocol gateway that is preconfigured
to automatically communicate between Veeder-Root’s devices (hereafter simply called “device”) connected to the
ProtoNode and automatically configures them for BACnet/IP, BACnet MS/TP, SNMP, Modbus RTU or Modbus
TCP/IP.
It is not necessary to download any configuration files to support the required applications. The ProtoNode is pre-
loaded with tested profiles/configurations for the supported devices.
The ProtoNode FPC-N54 is compatible with:
•
TLS-3XX Console RS-232/RS-485 Dual Interface Module
•
TLS-450PLUS Console RS-232/RS-485 Dual Interface Module
Contractor Certification Requirements
Veeder-Root requires the following minimum training certifications for contractors who will install and program the
equipment discussed in this manual:
Service Technician Certification (Previously known as Level 2/3):
Contractors holding valid Technician
Certifications are approved to perform installation checkout, startup, programming and operations training, system
tests, troubleshooting and servicing for all Veeder-Root Series Tank Monitoring Systems, including Line Leak
Detection. This certification includes TLS-3xx and TLS4xx certification training.
In-Station Diagnostics (ISD-PMC) Technician Certification:
ISD PMC Contractors holding a valid ISD/PMC
Certification are approved to perform (ISD/PMC) installation checkout, startup, programming, and operations
training. This training also includes troubleshooting and service techniques for the Veeder-Root In-Station
Diagnostics system. A current Veeder-Root Technician Certification is a prerequisite for the ISD/PMC course.
All service personal on site must comply with all recommended safety practices identified by OSHA and your
employer.
Review and comply with all the safety warnings in the manuals listed in this document above and any other
Federal, State or Local requirements.
Warranty Registrations
may only be submitted by selected Distributors.
Safety Precautions
The following safety symbols may be used throughout this manual to alert you to important safety hazards and
precautions
EXPLOSIVE
Fuels and their vapors are extremely explosive if ignited.
FLAMMABLE
Fuels and their vapors are extremely flammable.
ELECTRICITY
High voltage exists in, and is supplied to, the device. A
potential shock hazard exists.
TURN POWER OFF
Live power to a device creates a potential shock hazard.
Turn Off power to the device and associated accessories
when servicing the unit.
OFF
