12
Using QuickServer Web Configurator To Setup The Gateway
Connect The PC To QuickServer Via The Ethernet Port
•
Connect a CAT5 Ethernet cable (Straight through or Cross-Over) between the local PC and QuickServer.
•
The Default IP Address of QuickServer is 192.168.1.24, subnet mask is 255.255.255.0. If the PC and
QuickServer are on different IP Networks, assign a static IP Address to the PC on the 192.168.1.xxx network:
For Windows 10, Right click on
.
T
hen click on Network Connections>Change Adapter Options. Double
click on Local Area Connections. When the Local Area Connections Status box appears click Properties. Click
on Internet Protocol Version 4 (TCP/IPv4) then click Properties. When the Internet Protocol Version 4 (TCP/
IPv4) Properties dialog box appears, click, ‘Use the following IP address’ radio button and enter the ‘IP address’
and ‘Subnet mask’ entries shown in Figure 9, the click the OK button , then the Close buttons to exit.
Figure 9. Assigning Static IP Address To The PC
10
