1
Introduction
The QuickServer is an external, high performance building automation multi-protocol gateway that is preconfigured
to automatically communicate between Veeder-Root’s products (hereafter called “device”) connected to the
QuickServer and automatically configures them for BACnet MS/TP, BACnet/IP, Modbus RTU and Modbus TCP/IP.
It is not necessary to download any configuration files to support the required applications. The QuickServer is
pre-loaded with tested profiles/configurations for the supported devices.
The QuickServer ProtoNode is compatible with:
TLS-3XX Consoles hardware/software requirements:
• RS-232/RS-485 Dual Interface Module
TLS-4XX Consoles hardware/software requirements:
• RS-232/RS-485 Dual Interface Module
Contractor Certification Requirements
Veeder-Root requires the following minimum training certifications for contractors who will install and setup the
equipment discussed in this manual:
Installer Certification (Level 1):
Contractors holding valid Installer Certification are approved to perform wiring
and conduit routing; equipment mounting; probe, sensor and carbon canister vapor polisher installation; wireless
equipment installation; tank and line preparation; and line leak detector installation.
Technician Certification (Level 2/3):
Contractors holding valid Technician Certifications are approved to
perform installation checkout, startup, programming and operations training, system tests, troubleshooting and
servicing for all Veeder-Root Series Tank Monitoring Systems, including Line Leak Detection. In addition,
Contractors with the following sub-certification designations are approved to perform installation checkout, startup,
programming, system tests, troubleshooting, service techniques and operations training on the designated system.
• Wireless 2
• Tall Tank
Warranty Registrations
may only be submitted by selected Distributors.
Safety Precautions
The following safety symbols may be used throughout this manual to alert you to important safety hazards and
precautions
EXPLOSIVE
Fuels and their vapors are extremely explosive if ignited.
FLAMMABLE
Fuels and their vapors are extremely flammable.
ELECTRICITY
High voltage exists in, and is supplied to, the device. A
potential shock hazard exists.
TURN POWER OFF
Live power to a device creates a potential shock hazard.
Turn Off power to the device and associated accessories
when servicing the unit.
OFF
