Initial Setup Of The Console Using Workflow Wizard
Setup>Automatic Events>AutoXmit
49
Setup>Automatic Events>AutoXmit
This screen lets you set up
m
essages that auto
m
atically trans
m
it (AutoX
m
it) through an RS-
232 co
mm
unication port when alar
m
s are posted by the console.
NOTE: To use this feature, you need to have an RS-232
m
odule installed on your console. The
Diagnostics>Module>Co
mm
unication screen shows if this
m
odule is currently installed.
Comm Port
Touch to select a Co
mm
port for serial co
mm
unication (for exa
m
ple, "Co
mm
.id1")
NOTE: Only Co
mm
1 supports AutoX
m
it.
Delay Time (Secs)
Touch to enter an a
m
ount of ti
m
e in seconds (up to 240) to wait after an alar
m
is posted by
the console before the
m
essage is sent.
Repeat Time (Mins)
[Field applies If you select "
repeat
" for any alar
m
m
essage (see below)]
Touch to enter an a
m
ount of ti
m
e (up to 240
m
inutes) to wait before the console retrans
m
its
the
m
essage up until the alar
m
is cleared.
AutoXmit Alarm List
• Leak Alar
m
• High Water Alar
m
• Overfill Alar
m
• Low Li
m
it Alar
m
• Theft Alar
m
• Delivery Start Alar
m
• Delivery Stop Alar
m
• External Input On Alar
m
• External Input Off Alar
m
• Sensor Fuel Alar
m
• Sensor Water Alar
m
• Sensor Out Alar
m
Selecting Alarms to Automatically transmit.
1. The default selection is
Disable
- Do not trans
m
it a
m
es-
sage.
2. To trans
m
it a
m
essage for an alar
m
, in the field next to
that alar
m
, touch the drop down arrow to select Trans
m
it
or Repeat:
Transmit
- Trans
m
it one
m
essage when this alar
m
is
posted.
Repeat
- Trans
m
it a
m
essage continuously until the
alar
m
is cleared. Between trans
m
issions wait for the
period of ti
m
e specified in the
Repeat Time (mins.)
field above.
3. The second field below each alar
m
shows the string for-
m
at that controls how the
m
essage appears. Veeder-Root
reco
mm
ends that you accept the default selection.
