Site Prep - International Installations
Mounting the TLS-IB
2-6
Mounting the TLS-IB
Install the TLS-IB fastening devices to the mounting surface using the hole pattern 170 x 145mm (6.7 x 5.7 inches)
shown in Figure 2-3. Mounting screws up to 4.7mm (3/16-inch) diameter may be used.
Mount the TLS-IB to the mounting surface using the four mounting flanges on the back of the unit. Install ducting
or conduit between the TLS-IB and the power panel. Figure 2-3 shows the three designated knockouts (one each
on top, left side, and bottom) through which power wiring can safely enter the TLS-IB.
Figure 2-3. TLS-IB Dimensions And Designated Conduit Knockouts
0.34'' (8,6) typ.
0.34'' (8,6) typ.
7.4" (188)
6.4''
(163)
5.7''
(145)
2" (50)
5.3'' (135)
1.24''
(31)
5.3'' (135)
0.54" inside (M12 conduit),
1/2'' I.P.S. (International Pipe Size) outside (PG7 conduit)
knockouts 4 places - bottom (2), left side (1), and top (1)
1/2", 3/4'', & 1'' I.P.S.
conduit knockout pattern (2 places)
Cover (shown open
for reference)
tlsnt\ibdim.eps
0.22'' (5,6) dia.
mounting holes (4 places)
0.93'' (23)
0.93'' (23)
3''
(73)
0.7''
(17)
0.93''
(23)
6.7" (170)
NOTE: Numbers
in parenthesis are
in millimetres.
0.93''
(23)
