1-1
1 Introduction
This manual describes site preparation, installation, wiring and set up for TLS-IB consoles. Consult Table 1-1
below to determine the sections of this manual that will apply to your TLS-IB console.
Related Manuals
577013-578 TLS Monitoring Systems Contractors’ Site Preparation Guide
576013-858 Direct Burial Cable Installation Instructions
577014-031 TLS Magnetostrictive Probes International Installation Instructions
577013-744 Mag Plus Probe Installation Guide
576013-635 Veeder-Root RS-232 Serial Interface Manual
Contractor Certification Requirements
Veeder-Root requires the following minimum training certifications for contractors who will install and setup the
equipment discussed in this manual:
Installer Certification (Level 1):
Contractors holding valid Installer Certification are approved to perform wiring
and conduit routing; equipment mounting; probe, sensor and carbon canister vapor polisher installation; wireless
equipment installation; tank and line preparation; and line leak detector installation.
Technician Certification (Level 2/3):
Contractors holding valid Technician Certifications are approved to
perform installation checkout, startup, programming and operations training, system tests, troubleshooting and
servicing for all Veeder-Root Series Tank Monitoring Systems, including Line Leak Detection. In addition,
Contractors with the following sub-certification designations are approved to perform installation checkout, startup,
programming, system tests, troubleshooting, service techniques and operations training on the designated system.
• Wireless 2
• Tall Tank
Warranty Registrations
may only be submitted by selected Distributors.
Table 1-1. Applicable Manual Sections By Console Form Number
Section
TLS-IB Console Form Number
1
All
2
3
4
Applies To:
846620-180, 846660-180, 846690-180 (RS-232 with IFSF)
846620-380, 846660-380, 846690-380 (RS-232 w/o IFSF)
5
Applies To:
846620-580, 846660-580, 846690-580 (RS-232/RS-485)
