18
G
STARTING
G1
Preliminary checks, adjustments and
operational tests
G1.1
Electrical and plumbing checks
Before starting the machine:
•
check correct connection of the electrical wires that
feed the machine;
•
make sure the power supply voltage and frequency
match the data given in Table 1;
•
check correct connection of the water supply and
drain pipes (see par. E6 “Plumbing connections”);
•
make sure all the guards and safety devices are in
place and efficient.
G1.2
Check the positioning of tank components
G1.2.1
Check the fitting of filters and overflows
Make sure the filter "1", the overflow "2" and the flat filter
"3" are correctly fitted (Figure 14).
.
G1.2.2
Arm fitting check
Make sure the upper and lower wash and rinse arms are
correctly fitted (Figure 15).
G2
Starting
•
Open the water supply valves.
•
Turn the main switch of the machine to “I”.
•
Press the On/Off key Table 2 (“A” - “Control panel”).
G3
Detergent/rinse-aid dispensers and settings
If the appliance is connected to a water softener or
osmotic device, contact the detergent supplier for a spe-
cific product.
If the peristaltic dispensers are installed in the machine,
the detergent/ rinse aid dosage is made automatically
according to the desired concentration.
The detergent / rinse aid concentration depends on the
product type and the water supply hardness (check the
features on the product label).
IMPORTANT
The peristaltic dispensers (detergent and rinse aid)
and the tube inside the rinse aid dispenser require
periodical maintenance (at least once or twice a year)
or after prolonged periods of machine inactivity.
1. Dishwasher with incorporated detergent dis-
penser (Figure 16).
When the appliance is filled with water for the first time in
the day, pump “R” dispenses a detergent quantity in the
tank providing a concentration of 0.017 lb/gal (2 g/l). In
order to change this value, access the parameter
(see G4 Setting the dispensers).
At each cycle, pump “R” dispenses a detergent quantity
in the tank providing a concentration of 0.017 lb/gal (2 g/
l). In order to change this value, access the parameter
(see G4 Setting the dispensers).
Insert the supplied hose into the detergent container.
IMPORTANT!
These operations must only be carried
out by specialized technicians provided
with adequate personal protection equip-
ment (e.g. safety footwear, gloves,
glasses, etc.), tools and suitable ancillary
equipment.
IMPORTANT!
The following operations must be carried
out by operators provided with suitable
personal protection equipment (e.g. pro-
tective gloves, etc.) with the machine
switched off and cold.
Figure 14 Filters and overflow
3
2
1
Figure 15 Wash and rinse arms
