ENGLISH
19
2. Dishwashers with incorporated peristaltic rinse-
aid dispenser (Figure 16).
When the appliance is filled with water for the first time in
the day, pump “S” dispenses a rinse-aid quantity in the
boiler providing a concentration of 0.0008 lb/gal (0.1 g/l).
In order to change this value, access the parameter
(see G4 Setting the dispensers).
At each rinse cycle, pump “S” dispenses a rinse-aid
quantity in the boiler providing a concentration of 0.0008
lb/gal (0.1 g/l). In order to change this value, access the
parameter
(see G4 Setting the dispensers).
Insert the supplied hose into the rinse-aid container.
Connections for automatic detergent dispenser (Figure 16)
Figure 16 Automatic dispenser arrangement
There are two holes (plugged) “O” (Ø 3/16” [5 mm]) for
introducing the detergent. These holes may be easily
identified from outside by looking for the countersunk
marks on the external panel.
Inside the tank there is a hole “P” (Ø 3/8” [10 mm]) clo-
sed with a plug, which may be used for mounting a liquid
detergent injector.
Electrical connections for automatic detergent and
rinse-aid dispensers.
Terminals are available on the power supply terminal
board for the electrical connection of external dispensers
working at 208V or 240 V. Max. power 30 VA.
Figure 17 Detergent dispenser terminal block
•
Connect the
detergent dispenser
between terminals
7 and 9. These connection points are live for a set
time during filling of the tank and at the start of the
wash cycle (see paragraph G4 “Setting the dispen-
sers”).
Figure 18 Rinse aid dispenser terminal block
•
Connect the
rinse-aid dispenser
between terminals
8 and 9. These connection points are live during fil-
ling of the tank and at the end of the rinse cycle for a
set time (see paragraph G4 “Setting the dispensers”).
MANUAL ACTIVATION
Whenever the detergent containers are replaced, it may
be necessary to activate the dispensers manually in
order to fill the hoses and eliminate any air. Simultaneou-
sly press the buttons, as shown in the figures below. If
necessary, repeat this operation several times.
G4
Setting the dispensers
All operations should be carried out with the appliance
switched on, the hood open and no cycle selected.
Press the On/Off button ("A" - Table 2 "Control panel")
and Wash cycle 1 button ("E" - Table 2 "Control panel")
together for 5 seconds, to access the programming
mode and the display shows the parameter "
".
O
P
S
R
O
DETERGENT DISPENSER
RINSE-AID DISPENSER
USr
