tions port and connected with appropriate cabling.
Controller requirements will be dictated by the software application used to control the multiplexer.
Note: Any controller equipment (customer supplied) shall be grounded to the same protective
ground as the Multiplexer.
3.6 Ethernet
Before the Ethernet can be used, the IP address needs to be setup for your network. The default IP address, as
shipped for the factory, is 192.168.1.1. The Ethernet port may be configured from the front panel.
Press the Left or Right arrow keys until the IP address screen is displayed.
Use the Up & Down arrow keys to select STATIC or DHCP.
When STATIC is selected use the Left or Right arrow key to select the 2
nd
line IP address and use the Up and
Down arrows to sequence each digit in the IP address until the desired IP is displayed.
Press ENTER.
In addition, the Subnet Mask and Gateway must be setup.
From the IP Address screen, press the Left or Right arrow key to display the Mask & Gateway setup screen.
Press Enter and then use the Left and Right arrow keys to navigate to the desired digit to edit and use the Up
and Down arrow keys to select the desired digit. Repeat this process for each digit until the desired Subnet Mask
is displayed.
Press ENTER and use the Left and Right arrow keys to select the Gateway IP address and edit it as needed.
If DHCP is selected, the AT1700 will obtain an IP address, Subnet Mask and Gateway from your DHCP server.
Note that setup may now be completed via a simple web browser connection. See the Web
Browser Interface section 4.7.
Page 9 of 22
AT1700 series Manual D07-00-066P Rev. A00
