Protocol Tabs
337
Capture Trigger
Select the Capture Trigger event.
FRAME ERROR
RDI-P ALARM
B1 ERROR
LOP-P ALARM
B2 ERROR
PTR INCREMENT
B3 ERROR
PTR DECREMENT
REI-L ERROR
NO NDF ALARM
REI-P ERROR
NDF
BIT ERROR
BYTE EQUAL
AIS-L ALARM
BYTE NOT EQUAL
RDI-L ALARM
MANUAL
AIS-P ALARM
Match Value
This setting only appears when the Capture Trigger is set to
"BYTE EQUAL" or "BYTE NOT EQUAL".
Use the keypad to enter the byte value (in Hex) that the
selected byte's received value will either need to "equal" or "not
equal" in order to trigger the capture event.
Bytes After
Trigger
When a Capture event has been triggered, 256 overhead byte
values will be captured (from 0 to 255).
This setting is used to specify how many of those 256 bytes
should be captured immediately following the trigger, and in
turn how many of those 256 bytes should be captured
immediately preceding the trigger.
If 255 is entered (default), then the triggered byte value, and
the following 255 byte values after the trigger event will be
captured.
If 254 is entered (default), then the one byte immediately
preceding the trigger, the triggered byte value, and the
following 254 byte values will be captured.
If 100 is entered, then the 155 bytes immediately preceding
the trigger, as well as the triggered byte value, and the
following 100 byte values will be captured.
MPA_e_manual_D07-00-129P_RevA00
Summary of Contents for MPA
