Call - Data Setup
Pattern tab
SubAddress Type:
NSAP to select the Network Service Access Point subaddress
User to use a subaddress defined by a user (no standard applied)
When the test is finished, the screen displays a list of these services:
CLIP
: Calling Line Identification Presentation presents the Calling Party Number to the called user.
CLIR
: Calling Line Identification Restriction prevents the Calling Party Number from showing to the called user.
CFU
: Call Forwarding Unconditional diverts a received call to a specified different number.
COLP
: Connected Line Identification Presentation - the answering party's number is conveyed to the calling party.
COLR
: Connected Line Identification Restriction allows the connected subscriber to stop COLP from operating.
CFB
: Call Forwarding Busy Calls are forwarded to a specified number only when the subscriber (called party)'s number is
busy.
SUB
: Sub Address digit is added to an incoming call to specify an extension.
MSN
: Multiple Subscriber Number. Multiple full numbers are assigned to one BRI line.
CFNR
: Call Forwarding No Reply calls are forwarded to a specified number only when the subscriber (called party) does
not pick up the line in a specified amount of time.
DDI
: Direct Dialing In adds a number of telephone number to a circuit which can be used to dial that BRI (common use is
a company number with individual 4 or 4 digit extension numbers that can be dialed)
HOLD
: Call Hold - the user may interrupt a call, then reestablish it later. Interruption frees the associated B channel.
UUS
: User to User Signaling allows a user to send an Information message in the Setup, Alerting, or Connect message
on the D Channel, without connecting the call; the message shows on the ISDN phone display.
TP
: Terminal Portability; the ability to suspend and reconnect a call; for example, to move a phone from one plug to
another.
AOC-D/E/S
: Advice of Charge determines when charging information is available to the served user; during the call, when
the call is terminated, when the call is established.
MCID
: Malicious Call Identification. The called party, on a per call basis, requests the network to register the called party
phone number, the calling party number, and the date and time of the calls.
CW
: Call Waiting informs a user of an incoming call which has no B-ch available; user may accept, reject, or ignore.
CUG
: Closed User Group; a private network which restricts communication between members and nonmembers.
24.1.7 Multi Call
Type:
Single Number or Number Script
Mode:
Parallel or Sequential
Multi Call Setup (Page 1)
Multi Call Setup (Page 2)
_e-manual_D07-00-051P_RevD00
Summary of Contents for VePal TX130M+
