IP Tab:
In the IP tab the user must configure the destination IP address and source address. The user may also configure
the following IP header fields:
IP TOS (for Quality of Service testing):
Legacy TOS (Precedence):
The first three bits of the IP TOS field can be edited;
000 - Routine
001 - Priority
010 - Immediate
011 - Flash
100 - Flash Override
101 - Critical
110 - Internetwork Control
111 - Network Control
DSCP (Differentiated Services Code Point):
The first six bits of the IP TOS can be edited to provide more
granular service classification.
For more information on the definition of DSCP field in IPv4 and IPv6 headers, refer to
Time To Live (TTL):
Can be configured in the range 0 to 255
Fragment offset byte:
Can be configured in the range 0 to 65.528
Note:
The fragment offset field, measured in units of eight-byte blocks, is 13 bits long and specifies the
offset of a particular fragment relative to the beginning of the original unfragmented IP datagram.
Protocol:
UDP (0x11), TCP (0x06), or User defined
BERT Setup - IP Settings (DSCP
)
BERT Setup - IP Settings (Legacy TOS
)
_e-manual_D07-00-051P_RevD00
Summary of Contents for VePal TX130M+
