EN|ENGLISH
5
Fig. 3
1.
Clean the tool shank (item 1. Figure 2) and lightly grease with grease
grease (Item 2, Figure 2).
2.
Pull back the locking sleeve (item.2. Figure 3)
3.
With the simultaneous rotation of the tool in the tool, enter the slot
(Item 4. Figure 3) until it stops.
4.
Loosen the locking sleeve.
5.
Check the strength of the planting tool.
6.
Check for damage dust cover (item.5. Figure 3).
WARNING!
If the dust cover is damaged, it must necessarily replaced!
To remove the tool take away the locking sleeve (Item.2. Figure 3) back and
pull out the tool.
Your hammer can be operated in two modes:
1.
Rotation with a bang
- This mode is designed for drilling concrete,
brick, stone and foam.
2.
Strike
- This mode is intended for demolition work on the brick and
masonry materials and concrete-containing chipping tiles.
Rotation with a bang.
To set the hammer drilling must be the lever (Item 6. figure 4) rotate the
firing mechanism on the symbol "drill."
