EN|ENGLISH
6
Fig. 4
ATTENTION!
•
Switch mode can only be in a position to a full stoppunch.
•
In the process of drilling, hammering action is prohibited to put a lot of
effort hammer, it can only slightly be sent. The increased effort does not
increase the force of impact, and only creates unnecessary extra load on
the engine!
•
For maximum performance in drilling, hammering action should be to
work at maximum speed.
•
In order to avoid rapid wear of the striking mechanism, make sure that
the switch lever was always fixed in either of two operating positions.
•
mode of attack
•
To set the stroke to the lever (pos.6. Figure 5) the impact mechanism to
rotate the symbol "chisel."
ATTENTION!
If you feel that the gears are not included in the link, turn the chuck by
hand. Do not apply excessive force to the switch.
