63138-US-200110
13
You must observe the safety instructions in this operating instructions manual, the
national installation standards as well as the valid safety regulations and accident
prevention rules.
For safety and warranty reasons, only manufacturer authorized personnel may
perform any invasive work on the device beyond that described in the operating
instructions manual. Arbitrary conversions or modifications are explicitly
forbidden. For safety reasons, you must only use the accessories specified by the
manufacturer.
You must observe the safety approval markings and safety tips and understand their
meaning on the device to avoid any danger.
2.6 Installation and Operation in US & Canada
This information is only valid for the US and Canada. Hence the following text is
only available in the English language.
Installations in the US shall comply with the relevant requirements of the National
Electrical Code (ANSI/NFPA 70).
Installations in Canada shall comply with the relevant requirements of the
Canadian Electrical Code.
2.7 Safety Instructions for Ex Areas
Instruments with approvals can have different technical data depending on the
version. With these instruments, you must observe the corresponding approval
documents. These documents are part of the scope of delivery or you download
the documents from "www.vega.com", "
Instrument search (serial number)
" as
well as using "
Downloads
" and "
Approvals
".
The operator must check the suitability of the radiometric measuring principle as
well as of the instrument for use in hazardous areas by consulting the applicable
national regulations.
Note the following instructions:
Static charge
: Avoid electrostatic charges on the instrument. Never rub dry.
Potential equalization
: You must integrate the instrument in the potential
equalization of the system. Use lock washers to ensure a good electrical contact
between the source container and the mounting bracket.
Summary of Contents for SHLD 2
