Vega TL-11 / User Manual
11
Revision 03 - 07 September 2020
INITIAL STARTUP
Vega TL-11 is constantly ON, but can operate in a special "Storage" mode, designed for
storage and transportation. The device does not regularly transmit data to the network in this
mode. Before use switch the device from the “Storage” mode by the button pressing.
The temperature logger supports two activation methods in the LoRaWAN network -
ABP and OTAA. Select one of the methods using “Vega LoRaWAN Configurator” application
(See part 4).
1. ABP. After pressing the start button, the device immediately starts working in the
"Active" mode.
2. OTAA. After pressing the start button, the device makes three attempts to connect to
the network within the set frequency plan. After the activation in the LoRaWAN network is
confirmed, the device sends a signal (LED flashing for 5 seconds) and switches to the "Active"
mode. If all attempts fail, the device will continue to accumulate data and will attempt to
connect to the network every 6 hours.
To transfer the device from the "Active" mode to the "Storage" mode, you can use the
long press of the start button (more than 5 seconds).
Press the start
button located on
the board
