13
2 Loading or source exchange
Source loading and exchange • VEGASOURCE 31, 35
39155-EN-181126
Fig. 10: VEGASOURCE - version C in extraction position
•
If necessary, screw an extension rod (9) with thread M8 into
the socket of the source holder (8). With this extension you can
increase the distance to the source
•
Pull out the source holder (8)
•
If it is present, remove the safety bolt (5), Allen key size 2.5
•
Swivel the cover (6) in front on the thin cylinder of the source
holder (8) to the side. To do this, lift the cover (6) slightly with a
small slotted screwdriver
•
Only when exchanging the source: Allow the source capsule (7) to
fall out downwards into a shielded vessel
•
Insert new source capsule (7) and close cover (6). For insertion
use a suitable gripping device or a manipulator
•
Screw in the safety bolt (5) (optional)
•
Completely insert the source holder (8) into the source container
and turn it until the holding pin (3) pops out
•
If necessary, remove extension rod (9)
•
Continue turning the source holder (8) up to position OFF
•
Fit the padlock (1) and lock
•
Tighten locking screw (2)
•
Screw in capstan screw (4) and secure together with the retaining
pin (3) with new seal
•
Remove existing type labels (when exchanging the source)
•
Unpack the type label set and letter it respectively. You can find
further information in chapter "
Safety instructions - Labelling
"
Insert or exchange
source
Insert source holder
Attach or replace the type
labels
