5
2.3.1.5.
Specification of the support see Figure 2.3.1.2, 2.3.1.3 and 2.3.1.4; universal joint see Figure
bridges.
maintenance, as per Figure 2.3.1.1. The cable is connected to junction box by wire casings or
anchors or plug bolts. Junction box is always installed in positions that easy for installation and
be monitored to ensure the direction of the camera is correct; at last fasten the support with
base of the camera; after that adjust the fasteners of the universal joint based on the area to
Select
installation holes in proper positions, the first step is to mount the universal joint with the
2.3.1.
Support
installation
be harmed.
rotation of the camera; otherwise, falling or damage may happen, even personnel safety may
shall ensure that it’s out of reach by human beings and there is no other subject may affect the
fasteners comply with associate load and anti-rust requirements. Installation of the camera
It’s the user’s responsibility to ensure the support for the camera is strong enough, and the
significantly.
We strongly suggest you select supports from
VEILUX, it will ease your installation process
The
debugging is done before package, only installation in the intended location is required.
2.3.
Preparation
of supports before installation
Follow the instruction of the cable gland for correct installation.
compound, the Ex marking shall be Ex db IIC Gb/Ex tb IIIC Db IP68 or higher protection level.
product, please replace the stopping plug with ATEX certified cable glands with sealing
There are two cable entries in the rear cover that blocked by stopping plugs in packaged
2.2.
Cable entry
DO NOT OPEN WHEN
EXPLOSIVE GAS OR DUST MAYBE PRESENT!
No extra load on the camera, extra load may cause malfunction or damage!
SVEX-T100
Without
Wiper
/
SVEX-T300
With
Wiper
Explosion-proof
Camera
·
Instruction
Manual