[Figure 5-40. Motion Area Setup]
①
Select Motion Area of each channel.
②
It becomes the 1 channel division mode and rectangular boxes appear where motions occur. Drag the
yellow pixel cursor by using the mouse or the front button/remote controller and select pixels where motion
detection doesn’t applied. The selected area turns brown.
③
Select Exit to finish.
(1)Motion Sensitivity : Lowest/Low/Middle/High/Highest.
(2)PCD Time : Select between 2/3/4/5/6/7/8/9.
(3)Sensor Type : Select the sensor type.
(4)Sound Sensitivity : Lowest/Low/Middle/High/Highest
６
-
２
-
４
Relay
Select the relay type.
６
-
３
Action
The Main setup is to configure the environment of record and system and major functions.
In the real-time monitoring, move to
{Menu} {Setup} {Action}
[Figure 5-41. Setup / Action]
46
