1) After copying the upgrade file, be advised to get rid of the USB device with
safety removal mode from PC.
2) If the USB device is disconnected from the USB port while the upgrade file
is being copied, the DVR system may not automatically detect the file.
Removing USB during the upgrade in progress may cause damage on the
system.
The system starts over when the upgrade is completed.
(3) Firmware Upgrage
①
Select
{Firmware}
and the upgrade file list stored in the selected device and simple version information of
the selected file are then displayed.
Select a file and Firmware Upgrade window appears.
[Figure 6-48. Firmware Upgrade Progressing Window]
※
Downgrading to a previous version is not supported.
※
The upgrade information window will then appear within 15 seconds.
②
Read the information and select {Yes} to start the upgrade gradually. Select {No} to return to the
{System}
mode.
③
After the upgrade is completed, the system reboots.
④
Move to
{Menu} {Miscellaneous} {DVR Information} {3. Software Version}
to check the version.
(4) Setup Upgrade
①
Select
{Setup}
and the upgrade file list stored in the selected device and simple version information of the
selected file are then displayed.
②
Select a file and then the upgrade starts immediately.
Select a file and then the upgrade starts immediately
. All setting values of the
current menu will be changed to the upgrade setting values.
６
-
７
-
７
Factory Default
①
Move to {Menu} {Setup} {System} {7. Factory Setup}.
②
Select {Yes} when Initialization (Yes/No) Window appears.
Note that all setting data will be initialized.
※
All values go back to Factory Default Value.
57
