Veilux VR-412D1 & VR-412C Compact DVR’s
www.veilux.net
51
Operating Instruction & User’s Guide
①
Select the channel to be set up at
{Recording}
{Event}
{Motion Detection}
using the arrow
keys and the Select button.
②
Select {Partial} on the selection window. The selected channel turns into the 1 channel mode.
③
A green-small rectangle shows at every sells of the image.
[Figure 6-35. Motion Setup]
④
Move the blue-rectangle to the desired area for Motion Detection and press the Select button.
⑤
Using the arrow keys, designate the motion detection area and the green-rectangle will disappear.
Press the Select button.
⑥
to designate another area, repeat ④-⑤.
⑦
Exit Motion Setup by ESC in the front panel or the right-mouse button.
Method of Selecting the Zone
※ The [Select] button is operated by Toggling.
※ in the above description, the Select button means the button in the front panel
and the same function as double-click of the mouse.
(3) Off
Motion detection in the video is disabled.
(4) Select the motion detection sensitivity
①
In the selection window, select the sensitivity using the arrow keys and the Menu button. The
sensitivity can be set among
{Lowest} / {Low} / {Meddle} / {High} / {Highest}
.
Method of Setting the Sensitivity
Current sensitivity levels -- Lowest/Low/Middle/High/Highest -- indicate the
proportion of pixels within a block for which motion was detected. Therefore,
the higher the selected level is, the faster the motion that can be detected.
②
Sensor (Only VR-412D1 supported)
Summary of Contents for VR-412C
Page 1: ......
