Veilux VRHD-8-4SDI Operating Instruction & User’s
10
Guide
www.Veilux.net
１
-
６
-
１
Basic Connection
By referring to above
[Figure 2-1] and [Figure 2-2],
Connect the CCTV camera, CCTV monitor (or VGA monitor),
and USB mouse to the DVR and set up CONFIG SWITCH.
Connecting Device
DVR Terminal
1
CCTV camera
Rear Panel Video Input
2
CCTV monitor
Rear Panel TV
3
VGA Monitor / LCD Monitor
Rear Panel VGA-OUT
4
Mouse
on Front Left side
5
CONFIG SWITCH
Rear Panel NTSC/PAL or VGA/TV Setup
Refer to the CONFIG SWITCH description as below.
1. The input video type must be either NTSC or PAL; these two types must not be used together.
2. Select the input video format (NTSC/PAL) using the CONFIG switch on the rear side of the product.
3. Should select one between 1080p and 720p for input resolution. These two types must not be used
together. 8Ch DVR is setup 720P regardless of video input. (Please Note that the Veilux 8CH DVR will
only go up to 720P not 1080P. Even if switches are configure correctly.)
１
-
６
-
２
Connection of Other Devices
Connect the PTZ controller cable, audio in/output, network and sensors as below.
Connecting Device
DVR Terminal
1
SPOT Monitor(CCTV Monitor)
Rear Panel SPOT
2
Mike / Speaker
Rear Panel Audio Input / Audio Output
3
LAN Cable
Rear Panel Ethernet
4
PTZ Camera
Rear Panel Terminal Block
5
Sensor / Relay / TTL OUTPUT
Rear Panel Terminal Block)
6
Key controller
Rear Panel Terminal Block
1) SPOT Monitor
Connect Spot Monitor to the spot connector on the rear panel.
2) Audio In/Output
Audio supports 4 inputs and 1 output.
3) Terminal Block
Terminal Block on the rear panel is for the connections of PTZ / Sensor / Relay.
Summary of Contents for VRHD-8-4SDI
Page 1: ......
