In many cases, the installation site must be inspected by a qualified
electrician to determine the correct cable section and length.
Make sure to check that there is no electricity in any of the terminals before
making any electrical connections.
In case of any doubt, disconnect the main electrical current from the fuse
panel.
Peel off the isolated outside of the electrical cable in a length of
approximately 5 cm, and connection cables in a length of approximately
1 cm by using a suitable tool. In the meantime, the power cord should not
be damaged.
Insert the device's power cord into the cable entry.
Carefully connect the connecting cables to the electrical connection
terminals according to wiring diagram.
Tighten the screws of the connection terminals and make sure the cable is
completely isolated to remain below the attachment screws. Loose
connections can cause overheating of the cord.
The power cord must be secured in accordance with TSE standards in
terms of both its installation in the wall and its protection.
As with all electrical equipment because of weakenings that may arise due
to use and aging, device and its installation should be checked by a
qualified electrician with an interval of at least two years.
Do not turn on the electricity until the front cover of the device is closed.
Place the front cover on the back cover. Make sure that bearings on the
edge of covers are correctly placed in the slots on the back cover.
EN
-30-
Summary of Contents for FLOW
Page 40: ......
