EN
-32-
Important Tip
If the appliance does not start because of a reduced flow-rate, and low
water line pressure is not prevented, you can remove the flow-rate limiter at
the cold water supply inlet following the instructions provided below. Then
the rate of flow will increase and the appliance will begin to start.
Removing the flow regulator
First switch off fuse to disconnect electrical connection and close the inlet
water tap.
Remove the inlet water filter in accordance with the instructions provided in
the section
"Cleaning the water inlet filter"
on the following pages.
The plastic part serving as the inlet water flow regulator is in the inlet water
union behind the inlet water filter. You can use something like a knitting
needle to remove the regulator.
If you fail to remove the flow regulator this way, you can also use the
methods provided in instructions on the figures below or you can get a
qualified technician to remove the regulator.
Do not forget to put the flow regulator back its place after removing the flow
regulator.
Summary of Contents for FLOW
Page 40: ......
