Temperature Control
Device works automatically as sson as the hot water tap is turned on, and if
the inlet water pressure falls below the minimum level or the hot water tap is
turned off, the device will stop working automatically.
Electric instantaneous water heaters directly heat the water passing through
to the desired degree and meanwhile only consumes electrical energy.
Water temperature depends on entering water temperature, strength of the
device and the amount of water flow. The desired water temperature is
adjusted by changing the level switch with the help of heating capacity.
Besides, temperature is increased by reducing the temperature of the water
flow or the temperature is reduced by applying the reverse of this process.
If the water is continuously flowing hot and you cannot get any cold water,
first check if water inlet filter is contaminated or not or check if aerators of
sink pipe is clogged or not. If the fault is not eliminated, you can remove the
regulator in accordance with the instructions provided in the section
"Removing the flow regulator"
on the following pages.
The increase in the water temperature during normal operation is most likely
indicative of being reduced to a minimum inlet water pressure.
If the device feeds two or more taps output water at the same time, output
water will be divided between those taps. In winter time, it may not be
accessible to the desired output temperature due to the low inlet water
temperature.
Use
Step switch has three (1 - 2 - 3 ) positions.
Position '1' is preferred for reasons of economy in months when the inlet
water temperature is high.
Position '2' is used in months when the inlet water temperature is lower.
Position '3' is the highest level and a maximum water flow at the desired
temperature is obtained at this position. Normally, this position provides the
highest warm water performance throughout the year.
EN
-33-
Summary of Contents for FLOW
Page 40: ......