Hydro switch
If the water pressure drops below the the minimum level necessary for
operation of this device, hydro swtich gets activated. This device cuts off the
electricity supply to the heating elements water temperature in order to
prevent the water temperature to increase unexpectedly. In the meantime,
the water flow may continue. When water pressure reaches a sufficient level,
heating elements get automatically activated.
Thermal Circuit Breakers
In case of an excessive rise in the water temperature during normal
operation, power of the heating elements is cut and the water continues to
flow. It is a fault condition of the thermal circuit breaker to cut the power and
the source of the failure should be determined by a qualified technician and
re-commissioning of the system should be ensured.
Cleaning and Maintenance
Do not use strong abrasive or dissolving fluids to clean the device. These
substances may damage the plastic links.
The device itself can be cleaned with warm water using a soft cloth.
Cutting the power by turning of fthe braker is recommended before starting
the cleaning of the device. This process prevents accidental working of the
device while cleaning.
The pollution rate of the water used and the amount of lime in it determine
the cleaning cycle. For example, if the device is used everyday with a highly
polluted water cleaning should be done at least once a week.
The make sure that the device always works properly and safely, electricity
and water supplies should be checked by a qualified technician to at least
every two year.
EN
-34-
Summary of Contents for FLOW
Page 40: ......
