VELA
TANGO
VELA
TANGO
EL
VELA
TANGO
EL
1.
3.
2.
1 0
2.0. USER MANUAL
Replacement of the gas spring may only be performed
by the service support team from your dealer or a
skilled technical person.
2.0.3. CHANGING PLACE FOR HEIGHT ADJUSTMENT -
RIGHT/LEFT ARMREST OR SWITCH BOX (VELA TANGO EL)
Remove the plug from the back of the armrest and insert it into
the opposite armrest or bottom of the switch box.
Note
: Height function may only be used continuously for one
minute, then nine minutes of break.
2.0.4. ADJUSTMENT OF SEAT HEIGHT (VELA TANGO)
Adjust the seat height by pulling up the front lever placed on
your right hand side.
2.0.2. ADJUSTMENT OF SEAT HEIGHT (VELA TANGO EL)
Can be operated from the underside of both right and left
armrest - depending on where the plug is placed (see section
2.0.3.).
Note
: VELA Tango El is available with remote controlled height
adjustment (i.e. if caregivers must be able to adjust the height).
2.0.1. ATTACHING THE BACKREST
The lever (1) for backrest adjustment must be in open position. Press the
locking pin spring and push the backrest arm through the protective cap (2)
and through the hole. Tighten the lever afterwards. The lever for backrest
adjustment should be pulled through the protective cap (3) as shown!
Note
: The backrest arm must be pushed through completely so the pin
spring locks the backrest arm. Make sure it cannot be pulled out again.
