Display
(!)
Press the ON Stand-by key
From off to on
.5
1f.l..YJ.Q
o manage the unit via the contrai panel, this
also be switched on.
m1I\ '"'e onnected to the conditioner
- Turn the device on by activ ing the generalswitch
lf � "1e al switch is installed on the power line, this
m
i
Select one ofthe 4 operat,ng modes by p,essòng the relatòve key.
Jr
f..,:•
A
Jr
Jr
..li-
Jr
te the
�
evice
9.7
Heating/cooling operation modes setting
Key
Operation
�
Keep the Heating
I
Cooling key pressed for approx. 2 seconds to change the
mode between heating and cooling, which is indicated by the 2 symbols that
appear if heating or cooling is active.
When heating, the symbol displays when the set point is higher than ambient
temperature, both are off when the set point is lower.
Whencooling, thesymboldisplayswhenthesetpointislowerthanambient
temperature, both are off when the set point is higher.
9.8
Stand By
Key
Operation
<!)
Press and hold the ON Stand-By key for approx. 2 seconds. No illuminated
signals on the display at all means that the system is in stand-by (no operation).
Display
◊*
◊
*
Display
Off
The adjustment range is from 16 to 31 °C in intervals
of O.S
°
C.
The controller is very precise - set it to the required value an
wait for the controller to regulate itself according to the actual
room temperature detected.
lnstruction manual
Pag. 25 of 28
Date 2019-12-20