Velbus Signum IoT Gateway (VMBSIG-20) install guide
April 2024
Page
16
of
19
Factory Reset Your Signum
If your Signum is not functioning properly, you can try to resolve the issue by doing a full reset of
the Signum to factory defaults. This will delete all user accounts, dashboards, widgets, settings
and network settings without recovery option in the Signum. The configuration in other modules
in the Velbus installation, usually configured with VelbusLink, will be unchanged.
You will need physical access to your Signum to do a Factory reset.
Via Home Assistant:
Go to Settings / System
Chose Factory reset & press the reset button
